Regulátor KELLY KEB 24V-84V 150A-450A

pro BLDC motory
Napětí: 18-90V
Maximální proud: 150A - 450A
Rekuperace
Programovatelný
7 900,00 Kč
S DPH
Maximální proud (30s.)
Počet
Skladem

Oblíbená řada řídících jednotek pro BLDC motory s vyskou účinností a jednoduchým uživetelským nastavením. Pro široké spektrum aplikací od elektrických kol, motocyklů, skútrů až po elektrické lodní pohony.

 

Pozor, tato technika je určena pro profi použití a vyžaduje určité technické znalosti.

Laikům tuto jednotku neprodáváme, nedodáváme k ní ani český návod, pouze anglický.

 

Features:

  • Specially designed for electric bicycle and scooter.
  • Intelligence with powerful microprocessor.
  • Synchronous rectification, ultra low drop, fast PWM to achieve very high efficiency.
  • Electronic reversing.
  • Voltage monitoring on 3 motor phases, bus, and power supply.
  • Voltage monitoring on voltage source 12V and 5V.
  • Current sense on all 3 motor phases.
  • Current control loop.
  • Hardware over current protection.
  • Hardware over voltage protection.
  • Support torque mode, speed mode, and balanced mode operation.
  • Configurable limit for motor current and battery current.
  • Battery current limiting available, doesn’t affect taking off performance.
  • More startup current ,can get more startup speed.
  • Low EMC.
  • LED fault code.
  • Battery protection: current cutback, warning and shutdown at configurable high and low battery voltage.
  • Rugged aluminum housing for maximum heat dissipation and harsh environment.
  • Rugged high current terminals, and rugged aviation connectors for small signal.
  • Thermal protection: current cut back, warning and shutdown on high temperature.
  • Configurable 60 degree or 120 degree hall position sensors.
  • Support motors with any number of poles.
  • Up to 40,000 electric RPM standard. Optional high speed 70,000 ERPM, and ultra high speed 100,000 ERPM. (Electric RPM = mechanical RPM * motor pole pairs).
  • Brake switch is used to start regen.
  • 0-5V brake signal is used to command regen current.
  • Support three modes of regenerative braking: brake switch regen, release throttle regen,0-5V analog signal variable regen.
  • Configurable high pedal protection: the controller will not work if high throttle is detected at power on.
  • Current multiplication: Take less current from battery, output more current to motor.
  • Easy installation: 3-wire potentiometer will work.
  • Standard PC/Laptop computer to do programming. No special tools needed.
  • User program provided. Easy to use. No cost to customers.

General Specifications:

  • Frequency of Operation: 16.6kHz.
  • Standby Battery Current: < 0.5mA.
  • 5V Sensor Supply Current: 40mA.
  • Supply Current, PWR, 150mA.
  • Analog Brake and Throttle Input: 0-5 Volts. Producing 0-5V signal with 3-wire pot.
  • Full Power Operating Temperature Range: 0℃ to 50℃ (controller case temperature).
  • Operating Temperature Range: -30℃ to 90℃, 100℃ shutdown (controller case temperature).
  • Maximum Battery Current: Configurable

Downloads:

1100 ks

Mohlo by vás také zajímat